Grabit Screw Extractor 4 Piece

4 Piece GRABIT Screw Extractor

GRABIT Screw Extractor Features:

• Simple, Fast and Easy to use
• Engineered to Bite into damaged screw head
• Clean chips off toll and lubricate with oil after use
• The GRABIT Damaged Screw Remover is reusable
• Biting action allows power of drill to Torque out stubborn screws
• GRABIT extracts screws easily from wood, metal or plastic and removes screws made of any alloy, including soft screws

Remove damaged screw heads and extract free spinning screws with GRABIT! No other screw extractor removes damaged heads AND extracts free spinning screws. Remove rusted screws, free-spinning screws, deck screws and other damaged screws easily with the Alden Grabit.

Single Tool Fits Power Drills
The Grabit is a drill and extractor in one tool that removes screws with any type of damaged screw head, from any material. The Grabit is easy to use with 3/8" variable speed reversible drill. No more guesswork in matching drill size with extractor, as with manual tools. Grabit's quick connect chuck capability increases its ease of use. Simply drill, then flip and extract.

No Drill "Walking" or "Wandering"
Special machinery is used to impart a self-centering Winslow tip on the Grabit, which prevents drill "walking" or "wandering". This self centering feature of the Grabit also permits dynamic adjustment of the drilling angle to keep the tool on-center.

Tough Torque Really Works
The Grabit has deep, serrated edges on the extraction end of the tool, which are capable of biting into a damaged screw without slipping. A high degree of torque is applied to the screw to overcome even the greater resistance found in rusted screws, screws as long as 4 inches and screws in hard wood. Free spinning screws may also be removed with the Grabit.

Alden Grabit Operating Instructions

1. Insert GRABIT directly into drill or quick-change chuck-Burnishing end is showing
2. Set drill for reverse (counterclockwise).
3. Place Burnishing end of tool into damaged screw, slowly clean inside screw head until smooth. Note: Burnishing tool end in not to be used to drill a hole.

Removing

1.Remove Burnishing end from chuck, flip tool, replace into drill chuck-Remover end now showing.
2. Maintain reverse setting (counterclockwise).
3. Place Remover end of tool into now smooth screw head.
4. Apply firm downward pressure, drill at slow speed. Apply lowest level of power to the hand drill.
5. Remover end of GRABIT will thread into screw head and remove.